Practical Tips; Operation; Replacing The Appliance Attachment; Switching On/Off - Parkside PKGA 20-Li B1 Traduction Des Instructions D'origine

3. Plug the battery charger (14) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (14) from the
mains.
5. Pull the battery (9) out of the battery
charger (14).
Overview of the control display
(14a) on the charger (14):
Green LED lights up without battery in-
serted: Charger ready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Ensure that the ambient tem-
perature does not exceed
45 °C or fall below -20 °C
during work.
Wear ear protection.

Operation

Replacing the appliance at-
tachment
Secure the appliance against
switching on (see "Switch-
ing on/off") or remove the
rechargeable battery from
the appliance. There is an
injury hazard if the device is
switched on accidentally.
Wear safety gloves. The appliance
attachment might have heated up
after use.
Removing appliance attachment
1. Push the unlocking lever (5) into posi-
tion as far as the stop and then
hold it in this position.
2. Pull the unlocked appliance attachment
off (4/16/22/26).
Fitting appliance attachment
3. Push the appliance attachment
(4/16/22/26) along the guide rail
into the motor unit (6). It locks into
place audibly.
4. Allow the unlocking lever (5) to slide
back into position
5. Check that the appliance attachment is
secure by pulling on it.

Switching on/off

1. Switching on: Press the on/off switch
( 10).
By using the on/off switch (
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2. Switching off: Release the on/off
switch ( 10).
GB IE
.
10) you
41