Motor Unit With Multisander Attachment Pkga2; Motor Unit With Sabre Saw Attachment Pkga3 - Parkside PKGA 20-Li B1 Traduction Des Instructions D'origine

Motor unit with
multisander attachment
PKGA2
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear a protective mask during
grinding work.
Attaching/removing sanding
sheet
The sanding plate (
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (23) evenly
onto the sanding plate (21). Ensure
that the holes in the sanding sheet
are placed above the openings in the
sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (23) off
the sanding plate (21).
Connecting dust extraction
You can reduce dust production during
sanding by attaching a dust extraction
system.
1. Push the adaptor (24) into the opening
on the multi-sander attachment (22) as
far as the stop.
2. Connect a dust extractor suction hose
to the adaptor (24).
21) is fitted with
If necessary, you can connect the
suction hose of a vacuum cleaner
without reducer (25) to the adapter
(24).
Sanding
• Use a dust extraction system when
sanding with the multi-sander attach-
ment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
for fine sanding of primed
P 240
and painted surfaces
Motor unit with sabre
saw attachment PKGA3
Installing/changing the blade
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
GB IE
43