Charging Process; Removing/Inserting The Battery; Recharging The Battery - Parkside PKGA 20-Li B1 Traduction Des Instructions D'origine

GB IE
consult their doctor and the
manufacturer of their medical
implant before operating the
machine.

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charg-
er, check that the battery's
outer surface is clean and
dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
• To recharge the battery, only use a
charger belonging to the Parkside
X 20 V Team series.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
40
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
Battery
1. To remove the battery (9) from the ap-
pliance, press the release button (9b)
on the battery and pull out the battery.
2. To insert the battery (9), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the battery-op-
erated tool is ready for use

Recharging the battery

Ensure that the ambient tem-
perature does not exceed
50 °C or fall below 0 °C dur-
ing the charging process.
Do not subject the battery to strong
sunlight over long periods and
do not leave it on a heater (max.
50°C).
Allow a hot battery to cool before
charging.
The charging time is approx. 1 hour
(PAP 20 A1) or approx. 2 hours
(PAP 20 A3).
1. Remove the battery (9) from the appli-
ance if necessary.
2. Insert the battery (9) in the charging
compartment of the battery charger
(14).