Télécharger Imprimer la page

Scheppach HP800S Traduction Du Manuel D'origine page 33

Plaque vibrante

Publicité

Problem
Enginge fails to start
Engine runs erratically
Engine overheats
Engine will not stop when throttle control
is positioned at STOP, or engine speed
does not increase when throttle control is
adjusted
Compactor is dificult to control when
pounding (machine jumps or lurches
forward)
Problem
Trouble shooting
Cause
1. Spark plug wire disconnected
2. Out of fuel or stale fuel
3. Throttle control lever not in correct
starting position
4. Choke not in ON position
5. Blocked fuel line
6. Fouled spark plug
7. Engine flooding
8. Engine oil level low (Oil monitor
interrupts the ignition circuit)
1. Spark plug wire loose
2. Unit running on CHOKE
3. Blocked fuel line or stale fuel
4. Vent plugged
5. Water or dirt in fuel system
6. Dirty air cleaner
1. Dirty air cleaner
2. Air flow restricted
Debris interfering with throttle linkage
Too high engine speed on hard ground
Przyczyna
oleju przerywa zapłon)
Remedy
1. Attach spark plug wire securely to
spark plug
2. Fill with clean fresh gasoline
3. Move throttle control lever to starting
position
4. Throttle must be positioned at choke
for a cold start
5. Clean the fuel line
6. Clean, adjust gap or replace
7. Wait a few minutes to restart, but do
not prime
8. Fill crank case with proper oil
1. Connect and tighten spark plug wire
2. Move choke lever to OFF
3. Clean fuel line. Fill tank wirth clean,
fresh gasoline
4. Clear vent
5. Drain fuel tank. Refill with fresh fuel
6. Clean or replace air cleaner
1. Clean or replace air cleaner
2. Remove blower housing and clean
Clean dirt and debris
Set the throttle lever at lower speed
Sposób rozwi zania
(czujnik
33

Publicité

loading

Ce manuel est également adapté pour:

Hp1100sHp1300s590460290359046039035904604903