Setting Up The Resting Position; Removing The Child Car Seat; Removing Of Cover And Cleaning The Child Car Seat; Installing The Sun Canopy (Not Present In All Variants) - RECARO SALIA Notice D'utilisation

7. Setting Up The Resting Position

• To adjust the sitting position, loosen the locking mechanism by pulling the sitting position adjustment
lever (15) on the front of the seat shell (Fig. 28). You can now push the seat shell into the desired
position.
• Once the desired position is achieved, release the sitting position adjustment lever (15) and let it lock in
(Fig. 29). Check secure locking by pushing or pulling the seat shell.

8. Removing The Child Car Seat

• To remove the RECARO SALIA, lift the ISOFIX length adjustment lever (14) on the front of the child car
seat up, and pull the child car seat forward a little bit. Now, push the light-grey buttons on the ISOFIX
unlocking lever (18) down, and unlock the ISOFIX connectors by pulling these levers on both sides as
illustrated (Fig. 30). You can now remove the RECARO SALIA from the vehicle.
• The support leg can now be folded in.

9. Removing Of Cover And Cleaning The Child Car Seat

• The seat and seat belt may be cleaned with lukewarm water and soap. The belt lock can be rinsed out
with water if necessary.
• RECARO seat covers are machine-washable in accordance with the treatment label sowed into the
cover. Higher temperatures may cause the colours to fade. Never spin or dry the covers in a dryer, as
the fabric may come apart from the padding.
• Remove the Velcro fastener as illustrated to remove the shoulder padding from the fastening belts
(Fig. 31).
• As a next step, open the press studs on the pads and remove the shoulder belts (Fig. 32).
• Now, open the press studs on the back of the headrest (Fig. 33).
• You can now remove the head rest cover with a forward motion (Fig. 34).
• The back padding is attached to the headrest with press studs. After opening the press studs, you can
pull off the padding downwards (Fig. 35).
• To remove the bottom cover part, open the Velcro fasteners in the back area (Fig. 36).
• Pull the belt lock from the groin strap padding as shown in the illustration (Fig. 37).
• Loosen the cover by opening the Velcro fasteners on the outside of the seat shell (Fig. 38). You can
now remove the cover from the seat shell.
• The cover in the shoulder area can be removed once the press studs on the outside have been opened
and the cover has been detached from the hooks (Fig. 39).
• Thereafter, open the press studs in the back area (Fig. 40).
• You can now remove the shoulder cover as shown (Fig. 41).
• Before cleaning the cover of the seat insert (12), please remove the inserted foam parts (Fig. 42, 43).
• After washing, please let the cover dry completely before you re-install it in the reverse order.

10. Installing The Sun Canopy (not present in all variants)

• On both sides, guide the locking pin of the sun canopy into the shoulder support of the RECARO
SALIA at the marked locations (Abb. 44).
• Now, plug the cover into the circumferential cover groove (Fig. 45).
• The sun canopy can be opened or closed by pulling at its front end
(Fig. 46).
• There is, furthermore, and additional foldable element at the front end of the sun canopy.

11. General instructions

The instructions for use are in the compartment on the back of the child car seat. After use, they should
always be placed back there.
20