11 Désactiver L'antenne - IFM Electronic efector190 DTM425 Notice D'utilisation

Read Error Codes (updated after each read access on the TAG)
0x01 ISO_COMMAND_ERROR_NO_
RESPONSE
0x02 ISO_COMMAND_ERROR_RX_ERROR
Write Error Codes (updated after each write access on the TAG)
0x00 ISO_COMMAND_ERROR_NO_ERROR
0x01 ISO_COMMAND_ERROR_NO_
RESPONSE
0x02 ISO_COMMAND_ERROR_RX_ERROR
TAG error codes (updated after each read or write access on the TAG)
0x00 ISO_TAG_ERROR_NO_ERROR
0x01 ISO_TAG_ERROR_COMMAND_NOT_
SPECIFIED
0x02 ISO_TAG_ERROR_COMMAND_SYNTAX
0x03 ISO_TAG_ERROR_OPTION_NOT_
SUPPORTED
0x0F ISO_TAG_ERROR_OTHER
0x10 ISO_TAG_ERROR_BLOCK_NOT_
USABLE
0x11 ISO_TAG_ERROR_BLOCK_ALREADY_
BLOCKED
0x12 ISO_TAG_ERROR_BLOCK_NOT_
UPDATEABLE
0x13 ISO_TAG_ERROR_BLOCK_WRITE_
VERIFY
0x14 ISO_TAG_ERROR_BLOCK_LOCK_
VERIFY
8.11 Désactiver l'antenne
L'antenne de l'appareil peut être désactivée si l'objet "Antenna active" (index
RO 0x2151) est réglé à la valeur 0� Dans ce cas, plus aucun TAG n'est détecté,
puisque le champ magnétique de l'appareil n'est plus actif�
L'antenne est réactivée avec la valeur 1� Avec l'objet "Antenna active", des
interférences entre des appareils positionnés l'un à côté de l'autre peuvent être
évitées en désactivant les antennes des deux appareils en alternance�
Tête de lecture/écriture RFID avec interface CANopen
TAG did not answer, maybe the TAG is not
in the field anymore
Error while receiving the answer from TAG
(CRC Error, Framing Error, Collision etc�)
No error, command executed successfully
TAG did not answer; maybe the TAG is not
in the field anymore?
Error while receiving the answer from TAG
(CRC Error, Framing Error, Collision etc�)
No TAG error
The specific command is not supported�
Example: Command code error
Cannot recognize the command� The
number of blocks exceeds the limit�
Example: Format error
Specific options are not supported
Other errors
The specified block cannot be used
(or was not found)
The specified block has already been
locked and cannot be locked again
The specified block has already been
locked and its contents cannot be updated
The specified block could not be
programmed normally (a write verify error
occurred)
The specified block could not be locked
normally (a lock verify error occurred)
FR
21