Ecolab MULTRONIC Mode D'emploi page 26
Masquer les pouces
Voir aussi pour MULTRONIC:
- Notice technique (126 pages) ,
- Manuel technique (77 pages) ,
- Manuel technique (26 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The set point difference (LW) function is used to specify the absolute interval between
switching point 2 and the set point.
Value range: 0.0 mA to ±20.0 mA
The switch difference (X2SD) function can be used to specify a switch hysteresis around
switching point 2. The stated percentage refers to the absolute value of switching point 2.
Value range: 0.0 % to 30.0 %
Through selecting the module selection function one returns to the controller parameter
module selection.
Page 2 displays additional parameters on a second page of settings.
The follow settings are valid for the adaptive 2-point FUZZY controllers (aFUZa and
aFUZs):
Standard signal
controller
parameters page 1
(adaptive 2-point
FUZZY)
The set point (W) function is used to specify the nominal value within the measuring range.
Value range: 0.0 mA to 20.0 mA
The set point difference (LW) function is used to specify the absolute interval between
switching point 2 and the set point.
Value range: 0.0 mA to ±20.0 mA
The switch difference (X2SD) function can be used to specify a switch hysteresis around
switching point 2. The stated percentage refers to the absolute value of switching point 2.
Value range: 0.0 % to 30.0 %
Through selecting the module selection function one returns to the controller parameter
module selection.
Page 2 displays additional parameters on a second page of settings.
The following settings apply to the 3-point-FUZZY controller:
Standard signal
controller
parameters page 1
(3-point FUZZY)
The set point (W) function is used to specify the nominal value within the measuring range.
Value range: 0.0 mA to 20.0 mA
The set point difference (XSH) function is used to specify switching point 2. The stated
percentage refers to the nominal value.
Value range: 0 % to 20 %
Through selecting the module selection function one returns to the controller parameter
module selection.
Page 2 displays additional parameters on a second page of settings.
417101810_Anhang06_Normsignal.doc
Standard signal measuring module
- 26 -
Rev.: 05-07/10
Publicité
Table des Matières
