Measuring Parameters - Ecolab MULTRONIC Mode D'emploi

The time periods for the controllers must be within realistic limits.
NOTE
min. controller on-time < controller cycle time < max. metering time
Through selecting the module selection function one returns to configuration module
selection.
The first page of the standard signal module configuration menu is opened through
selecting page 1.
4.2

Measuring parameters

The main menu for adjusting the Multronic is accessed through operating the ↑ key in the
measuring mask.
Main menu
The measurement parameters are selected through placing the cursor onto the selected
item and operating the ENTER key.
Measurement
parameter module
selection
(not available at
Multronic OC!)
The standard signal measuring module that is to be parametered can now be selected. To
do so, move the cursor onto the corresponding selected item and operate the ENTER key.
The following measurement parameters can be adjusted for the standard signal measuring
module.
Measurement
parameter
(standard signal)
The standard signal 1 function is used to specify the unit in which the measured value from
standard signal channel 1 is displayed.
Value range: pH / redox / chlorine / mA / mV / conductivity / Celsius / Fahrenheit
The measured value for the first channel is displayed in caps.
The measuring range 1 function is used to specify the measuring range for the first channel
of the standard signal module.
Value range (depending on the measuring signal selection)
Measuring signal
Conductivity
Chlorine
There are no settings for the measuring ranges of other signal settings.
417101810_Anhang06_Normsignal.doc
Standard signal measuring module
Value range
0..2 mS / 0..20 mS / 0..200 mS / 0..2000 mS
0..2 mg/l / 0..20 mg/l
- 22 - Rev.: 05-07/10