Controller Parameters - Ecolab MULTRONIC Mode D'emploi

The standard signal 2 function is used to specify the unit in which the measured value from
standard signal channel 2 is displayed.
Value range: no signal / pH / redox / chlorine / mA / mV / conductivity / Celsius / Fahrenheit
The measured value for the second channel is displayed in small writing below the first
channel. The no signal function turns the display function for the second channel off.
The measuring range 2 function is used to specify the measuring range for the second
channel of the standard signal module.
Value range (depending on the selected measuring signal)
Measuring signal
Conductivity
Chlorine
There are no settings for the measuring ranges of other signal settings.
The input current function is used to allocate the current loop signal of the measured
variable.
Value range 0..20 mA / 4..20 mA
The output current function is used to allocate the output signal.
Value range: 0..20 mA / 4..20 mA
The module selection function can be used to return to the measurement parameter module
selection.
4.3

Controller parameters

The main menu for adjusting the Multronic can be accessed through operating the ↑-key in
the measuring mask.
Main menu
The controller parameters function can be selected through placing the cursor onto the
selected item and operating the ENTER key.
Controller parameter
module selection
(not available at
Multronic OC!)
The electrodeless C-measuring module that is to be parametered can now be selected. To
do so, move the cursor onto the corresponding selected item and operate the ENTER key.
The adjustment of the electrodeless C controller parameters is carried out on two pages.
The functions displayed on the first page (page 1) depend on the settings of the controller-
type in the module configuration menu and on the main measurement variable (measuring
channel 1) set in the measurement parameter menu. The first page describes the settings
for the main measurement variable mA. The respective module descriptions contain
information on the other main measurement variables.
417101810_Anhang06_Normsignal.doc
Standard signal measuring module
Value range
0..2 mS / 0..20 mS / 0..200 mS / 0..2000 mS
0..2 mg/l / 0..20 mg/l
- 23 - Rev.: 05-07/10