Ryobi RSH2845T Traduction Des Instructions Originales page 6

MATERIAL SHREDDING METHOD
Twigs and up to Feed into the feeding
6 mm diameter. hopper at a rate which the
product will accept without
overloading.
Branches and Clip off all side growth
up to 45 mm in with secateurs before
diameter. feeding into the feeding
hopper.
Bedding plants, Knock soil and stones off
weeds and the roots to avoid damage
shrubby growth. to the blades.
Freshly cut With any material having
foliage, hedge, a high moisture content it
and kitchen is advised to feed in some
waste.(I.e. drier sticks at regular
cabbage leaves, intervals to help push the
vegetable material trough the cutting
peelings etc.) assembly and prevent it
from clogging.
Dry sticks and By inserting these at the
twigs end of your shredding
task, this will help to clean
the moisture and plant
sap from the inside of the
product and the cutting
assembly.
Do not allow garden waste to accumulate
before shredding as it will begin to compost,
become too damp and clog the cutting
assembly. Dry material will help most material
to clear the ejection chute. Save some dry
sticks until last to help clean the blade area.
Frequently monitor the build up/collection of
shredded material.
The exit of the discharge chute must be clear
at all times to prevent blockages.
When the collection box is full, turn the
product Off before emptying.
WARNING
Do not put your hands up inside the
shredder's discharge chute to clear away
shredded material while the product is
switched on or connected to the mains
supply. The blades are sharp. Wear heavy-
duty gloves and exercise extreme caution
when cleaning and clearing blockages.
4 | English
WARNING
When feeding long woody branches/stems
into the product be careful of whip and
vibrations as they get caught by the cutter.
The operator must wear eye protection
whenever using the product.
WARNING
The cutting device has a tendency to pull
branches/stems into the product. Do not
try to impede entry of the material being
cut once feeding has started. Always wear
gloves to prevent skin lacerations when
feeding material into the product.
NOTE: In normal use, do not switch off the
product until all of the shredded material has
cleared the cutter assembly. If the product is
switched off too quickly, remaining pieces of
material may clog the blade assembly and stall
the motor when the product is switched back on.
SYMBOLS ON THE PRODUCT
Read and understand all
instructions before operating the
product, follow all warnings and
safety instructions.
objects. Keep all bystanders,
especially children and pets,
at least 15 m away from the
operating area
Danger - Rotating blades. Keep
hands and feet out of openings
while the product is running.
Switch off and remove plug from
mains before maintenance or if
cord is damaged.
Wear eye and ear protection.
Do not use as a step.
Wait until all machine
components have completely
stopped before touching them.