Ryobi RSH2845T Traduction Des Instructions Originales page 5

Always clean the product immediately after
use. Wherever possible use a stiff brush
inside the feed and discharge chutes and a
dry cloth on the outside of the product.
Do not allow material to become dry and
hard on any of the product surfaces, but
particularly on the blades. This will directly
affect the shredding performance.
Make sure that the feed hopper and the
ejection chute are kept clean and clear of all
waste material
Make sure that all nuts, bolts and screws
(except the adjusting screw) are tight and
secure.
Always have any damaged or worn parts
repaired, or replaced by qualified personnel
at an approved Ryobi service centre.
Never attempt to bypass the interlock
switches on the collection box or the front
cover of the cutter assembly.
WARNING
petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Never
products, or any solvents to clean tool. Most
plastics are susceptible to damage from
various types of commercial solvents and
may be damaged by their use.
You may perform
described in the manual, for other repairs or
advice seek the assistance of an approved
Ryobi service centre.
SHAVING PLATE ADJUSTMENT
If the product fails to shred material, the
shaving plate may need adjusting.
NOTE: Adjusting the shaving plate should
only be attempted when deemed totally
necessary. Adjusting the shaving plate too
often or too far could cause the product to
cease working.
Ensure the product is turned on and working
in normal forward direction. Adjusting the
shaving plate while the motor is turned off
could lead to serious damage of the product.
While the product is still running, turn the
adjusting knob clockwise. When you hear the
metal-on-metal contact or see fine aluminium
maintenance tasks
shavings falling out of the discharge chute,
stop adjusting the knob.
INTENDED USE
The product is designed for reducing organic
garden waste materials such as branches,
twigs and foliage to small pieces and is for
use outdoors in a stationary position by an
operator standing on the ground. The product
is not intended for non-organic material, metal
or material which exceeds its maximum cutting
capacity of 45 mm diameter.
The product must be mounted on the stand
provided and must be used with the collection
box provided. It must not be mounted in any
other way than shown in this manual.
RESIDUAL RISK
Even when the product is used as prescribed, it
is still impossible to completely eliminate certain
residual risk factors. The following hazards may
arise in use and the operator should pay special
attention to avoid the following:
Exposure to noise can cause hearing injury.
Wear ear protection and limit exposure.
Inhalation of dust and particles. Wear dust
mask / filter when necessary.
Contact with the cutting mechanism. Keep
unprotected body parts away from the cutting
mechanism at all times.
KNOW YOUR PRODUCT
See page 139
1. Handle
2. Overload protection switch
3. On/off switch
4. Direction switch
5. Feeding chute
6. Shaving plate adjusting knob
7. Collection box
8. Wheel
9. Power cord
SHREDDING GUIDE
For best results when shredding, follow the
guidelines shown in the table below.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
English | 3