Ryobi RSH2845T Traduction Des Instructions Originales page 3

GENERAL SAFETY RULES
WARNING
The product is not intended for use by
children or persons with reduced physical,
mental or sensory capabilities. Young
children should be supervised at all times
by someone other than the operator to
ensure that they do not play near or with the
product.
WARNING
When using the product, basic safety
precautions should be followed to reduce
injury. Read all of these safety instructions
carefully before operating the product.
Make sure you are familiar with the controls
and the proper and safe use of the product.
Please keep these instructions safe for later
use.
TRAINING
Become familiar with the user guide before
attempting to operate the product.
Never allow children or people unfamiliar
with these instructions to use the product.
Local regulations may restrict the age of the
operator.
The operator or user of the product is
responsible for accidents
occurring to other people or their property.
PREPARATION
Do not allow children to operate the product.
Do not operate the product in the vicinity of
bystanders, especially children and pets.
Wear ear protection and safety glasses at all
times while operating the product.
Always wear protective non-slip footwear and
long trousers. Avoid wearing clothing that is
loose fitting or that has hanging cords or ties.
Only operate the product in open space (e.g.
not close to a wall or a fixed object) and on a
firm, level surface.
Do not operate the product on a paved or
gravel surface where ejected material could
cause injury.
Before starting the product, check that all
screws, nuts, bolts, and other fasteners
are properly secured and that guards and
collection box are in place. Return to an
authorised service centre to replace damaged
or unreadable labels.
Before use, check the supply and extension
cord for signs of damage or aging. If the cord
becomes damaged during use, disconnect
the cord from the supply immediately. Do
not touch the cord before disconnecting the
supply. Do not use the product if the cord is
damaged or worn.
ELECTRICAL SAFETY
Read these safety instructions thoroughly
before connecting the product to the mains
supply.
Before switching on, make sure that the
voltage of your electricity supply is the same
as that indicated on the rating plate. The
manufacturer recommends you connect to a
power socket protected by an RCD with a trip
of 30 mA.
Connecting it to any other power source may
cause damage.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
If you need to use an extension cord, ensure
it is suitable for outdoor use and has a current
capacity rating sufficient to supply your
or hazards
product. The extension cord cable should be
marked with either "H05 RN-F" or "H05VV-F".
Check it before every use for damage, always
uncoil it during use because coiled cords can
overheat. Damaged extension cords should
not be repaired, they should be replaced with
an equivalent type.
A power spike causes voltage fluctuations
and may affect other electrical products in
the same power line. Connect the product
to a power supply with an impedance equal
fluctuations. Contact your electric power
supplier for further clarification.
SPECIFIC SHREDDER SAFETY RULES
OPERATION
Before starting the product, look into the
feeding chamber to make certain that it is
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
English | 1