Operation - Beurer EM 38 Mode D'emploi

• Release the magnetic connection by
gently pulling the control unit away from
the belt. You can feel the magnetic
connection of the two contact buttons
unsnap.
• Pull the unit upwards and out of the
holder.
• Open the battery compartment [4] by
pushing the cover downwards at the ar-
row mark.
6

Operation

General information about use
The back belt is intended for individual
treatment of pain in the lower back area.
Do not switch on the unit until
the belt is fitted correctly. See
item 5.
Switching on the unit
Press and hold down the on/off button [1]
until a brief signal sounds and the LCD
display [5] switches on. When the unit is
started for the first time, Program A is acti-
vated automatically.
• Insert 3 x 1.5 V batteries, type AAA (LR
03 Micro). Ensure the correct polarity.
See the diagram inside the battery
compartment.
• Do not use any rechargeable batteries!
Selecting the program
Press the program button P [3] to switch
through the programs. The following pro-
grams are available:
Program Frequency
A 4 Hz – 110 Hz
(3 phases)
B 4 Hz
C 2 Hz (burst)
D 100 Hz
Note:
For program A, you can feel the
effect become stronger when swit-
ching from phase 1 to phase 2 (af-
ter approx. 10 minutes). This is
normal and intentional.
If the intensity seems too high, de-
crease it using the
ton [2].
Time
30 min.
25 min.
25 min.
25 min.
intensity but-
23