Tables - Georges Renault DEVICE NET Manuel Opérateur

6159932680-01
English
22/28

7 - Tables

7.1 - Station writing area
Station 1
Acyclic request
Mapping
Class 100
Address Instance Attribute Address
0x10
0x0202
... 0x11
0x0205
0x0206 0x12
0X0208
... 0X13
0X0235
Note 1
"Cycle number selection"
This data is taken into account only when the "Source of cycle number" option is set to "PLC" in the tightening controller.
Note 2
"Spindle validation"
This data is taken into account only when the "Spindle validation" option is set to "PLC" in the tightening controller.
This list is a 32-bit word. Each bit corresponds to a spindle.
A list of spindles is coded as follows:
Byte Relevant spindles
no.
1st byte Spindles 25 to 32
2nd byte Spindles 17 to 24
3rd byte Spindles 9 to 16
3rd byte Spindles 1 to 8
Note 3
The purpose of writing the specific code in the memory is twofold:
♦
Memorizing a code in the tightening results of the controller.
♦
Selecting a cycle from a code. In order to use the code as source of cycle number, you must position the options
as follows:
- "source of cycle no." option on "Bar code".
- "read by PLC" option in the bar code parameters.
Note: The PLC must program the specific code and its length in one entry. When the controller takes the specific code into
account, it resets the length.
Station 2
Acyclic request
Mapping
Class 100
Instance
0 0x20
0x0402
0 ... 0x21
0x0405
0 0x0406 0x22
0X0408
0 ... 0X23
0X0435
Operator's Manual
DEVICE NET
Attribute Description
Cycle number
0
selection (cycle no.)
0 Spindle validation
0 Specific code length
Specific code (Bar
0
code writing)
Size
Access Value
bytes
Note 1
R 2
(0.31)
W/R 4 Note 2
Note 3
W/R 2
0 – 30
Note 3
W/R 30