Programming The Cycles; Type Of Data; Cycle Phase Parameters; Header - Georges Renault DEVICE NET Manuel Opérateur

6 - Programming the Cycles

The function to have access to the data of a phase is available in the TWINCVI/MODCVI.
WARNING: it is not available in MULTICVI's or in MULTICVIC's.
This function allows the user to modify, via the field bus link, the parameters of a phase already programmed. However, it
allows you to access the data such as rotation speed, direction of rotation and power.
Through this functionality, you can neither modify the type of a phase, nor add a phase or delete a phase. The cycles shall
therefore be programmed beforehand, using either the keyboard of the TWINCVI, or the CVIPC2000 software on the PC.

6.1 - Type of data

Acyclic request
Mapping
Address Instance
0X0600 0X70
0X0650 0X38

6.2 - Cycle Phase Parameters

@ Byte
0X600 Reserved: structure identifier
0X602 Station no.
0X603 Cycle no. (from 1 to 250)
0X606 Phase no.
0X608 Spindle no.
0x60A Type of phase
0x60C Phase data
6.2.1 -

Header

To access the data of a phase, it is necessary to know:
The station number:
'1' or '2' in an asynchronous configuration of the CVI, 1 in a synchronous configuration.
The cycle number:
from "001" to "250"
The phase number:
from "01" to "20"
The spindle number:
"01" in an asynchronous configuration of the CVI
" 01" , "02" or "**" for the 2 spindles, in a synchronous configuration
Operator's Manual
DEVICE NET
Class 100
Attribute
0X00 Cycle phase parameters
0X00 Control word
Description
Description
Access Size
W/R 2 0x0001
W/R 1 "X "
W/R 3 "XXX"
W/R 2 "XX"
W/R 2
W/R 2 "XX"
W/R 68 "XX ............ XX"
Total = 80
6159932680-01
English
13/28
Size
Access Value
bytes
W/R 80
W/R 2
Value Type
Word
ASCII
ASCII
ASCII
ASCII
ASCII
Structure