Disposal And Recycling; Troubleshooting - Scheppach HS105 Traduction Des Instructions D'origine

15. Disposal and recycling

Disposing of transport packaging
The packaging protects the machine from damage during transport. The packaging material is usually chosen for factors of
environmental friendliness and disposal. It can therefore be recycled. Returning the packaging to the material life cycle saves
raw material and reduces waste.
Packaging parts (e.g. plastic sheets, Styropor®) can be dangerous for children. Risk of choking! Store packaging parts beyond
the reach of children and dispose of them as soon as possible.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the
Directive (2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed
of at a designated collection point. This can occur, for example, by handing it in at an authorised collecting point for
the recycling of waste electrical and electronic equipment. Improper handling of waste equipment may have negative
consequences for the environment and human health due to potentially hazardous substances that are often contained in
electrical and electronic equipment. By properly disposing of this product, you are also contributing to the effective use of
natural resources. You can obtain information on collection points for waste equipment from your municipal administration,
public waste disposal authority, an authorised body for the disposal of waste electrical and electronic equipment or your waste
disposal company.

16. Troubleshooting

Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
No motor output turns Overload by dull saw blade, thermoprotection
off automatically is triggered
Burns on the cutting a) Fastening nut tightened insufficiently
surface b) Wrong saw blade
c) with longitudinal cuts c) Longitudinal stop not parallel
d) with cross cuts
d) Slide carriage not parallel
30 І 60
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Help
Tighten fastening nut, M20 left-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be turned
on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade