EHEIM aquapro LED Mode D'emploi page 14

English
aquaproLED 180
‧ EHEIM classicLED LED light (4263011)
‧ EHEIM thermocontrol aquarium heater (3616010)
‧ EHEIM aquaball interior filter (2403020)
5. Assembly
Location
‧ Avoid direct sunlight, and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Be mindful of the floor load provided by the entire weight.
Setting up and aligning the base cabinet (⌦A)
1. Place the base cabinet in the desired position.
2. Align the base cabinet horizontally using a spirit level.
‧ Ensure the stability of the base cabinet. We recommend the EHEIM aquarium base cabinets available in specialist
shops.
‧ A stand can be used for horizontal alignment. Ensure that the stand rests fully on the surface.
Setting up the aquarium (⌦B)
WARNING! Personal injury or material damage.
The aquarium must not be transported or carried when in its filled state.
CAUTION! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium incl. lower frame a on the base cabinet.
6. Commissioning
DANGER! Personal injury or material damage.
▶ Heed the operating manual for the EHEIM classicLED LED light, EHEIM thermocontrol aquarium heater and the EHEIM
aquaball interior filter, especially the chapters on safety, commissioning, operation and maintenance.
Installing the EHEIM aquaball interior filter b and the EHEIM thermocontrol aquarium heater c
1. Prepare the appliances as described in the relevant operating manual.
2. Remove the cover from the aquarium from above (⌦C).
3. Install the appliances on the inner side of the aquarium as described in the relevant operating manual (⌦D).
14