EHEIM aquapro LED Mode D'emploi page 13

English
‧ Repairs must only be carried out by an EHEIM service centre.
‧ Only carry out the work described in these instructions.
‧ Only use original spare parts and accessories for the appliance.
‧ The appliance must be protected by a residual current protection device with a
maximum rated residual current of 30 mA. Please contact an electrician if there are
any questions or problems.
‧ In the event of leakage or when the residual current protection device is triggered,
immediately disconnect all devices in the aquarium from the power supply.
‧ If they are not being used, always disconnect all devices in the aquarium from the
power supply before you install/remove any parts and before all cleaning and mainte-
nance work.
‧ Heed the operating manuals for the EHEIM classicLED LED light, EHEIM thermocon-
trol aquarium heater and the EHEIM aquaball interior filter, especially the chapters on
safety, commissioning, operation and maintenance.
‧ Protect the mains socket and mains plug against moisture. It is recommended to form
a drip loop with the mains cable to prevent any water running along the cable to the
mains socket.
‧ The electrical data of the appliance must match the data of the power mains. This
data is found on the type plate, the packaging and in these instructions.
‧ The distance from the underside of the light to the highest water mark must be a
minimum of 15 mm.
4. Preparation
Unpacking
‧ Carefully remove all components from the packaging and make sure that nothing is missing or damaged.
Accessories
The scope of delivery contains the following accessories:
aquaproLED 84
‧ EHEIM classicLED LED light (4261011)
‧ EHEIM thermocontrol aquarium heater (3613010)
‧ EHEIM aquaball interior filter (2402020)
aquaproLED 126
‧ EHEIM classicLED LED light (4262011)
‧ EHEIM thermocontrol aquarium heater (3614010)
‧ EHEIM aquaball interior filter (2402020)
13