Data-Hold Function; Animal Weighing Function - KERN and SOHN 4.3 Mode D'emploi

5.7.1

Data-Hold function


Switch on the balance, keep the HOLD-key pressed until the current setting „Hx"
(H1 – H6) appears.

Press ON/OFF button repeatedly until the desired setting „H1-H4" is displayed.

Confirm setting with the HOLD button.

Suspend the material to be weighed

The weight value is fixed and displayed depending on the setting (H1 – H4) (see
chap. 5.7), represented by the [] in the upper left.
5.7.2

Animal weighing function

This function is suitable for busy weighing procedures. The result is a mean value
formed by 16 weighing values which is found out within 3 seconds.

Switch on the balance, keep the HOLD-key pressed until the current setting „Hx"
(H1 – H6) appears.

Press ON/OFF button repeatedly until the setting „H5" is displayed.

Confirm setting with the HOLD button.

Suspend the material to be weighed

Press the HOLD-key, the display counts reverse from 3 -1.
The calculated mean value is indicated, symbolised by the [] top left.

Before further measurements press first the ON/OFF/TARE-key.
HCB_HCN-BA-e-1543 32