Subsequent Tare Weight; Hold Function; Display Additional Decimal Point - KERN and SOHN MTA 400K-1M Notice D'utilisation

11.2.1 Subsequent tare weight

The balance can be tared several times successively. This function can be enabled
or disabled. For that make in the menu the following setting:
• Menu setting:
[F5 Str]  [Str on] (see chap. 12)

11.3 HOLD function

The balance has an integrated standstill function (mean value calculation). With this
function it is possible to weigh people accurately even if they do not stand still on the
weighing plate.




(example)
There is no average value calculation in the event of too much
movement.

11.4 Display additional decimal point

(short-time additional decimal point)
Press and hold for about 2 s whilst weighed result is being shown. The second
decimal place will be shown for approx. 5 s.
This value is not considered as verified and must not be used for purpose definition
of a verified balance.
30
Start balance by pressing
Wait for stability display „STABLE to appear.
Press , in the display „---------" will appear and the
„HOLD" symbol appears.
Allow the person to step onto the centre of the weighing
platform.
After a short time the stability display „STABLE" appears and
the weighing value of the person is displayed and „frozen".
After unloading the balance, the weighing value remains
displayed for approx. 10 seconds, than the balance changes
automatically into the weighing mode.
The „HOLD" symbol disappears.
.
MTA-M-BA-e-1612