Anslut 013741 Mode D'emploi page 12

EN
INSTALLATION
1. Switch off the power supply.
2. Remove the bracket from the housing.
FIG. 1
3. Use the bracket as a template to mark out
the mounting holes. Drill holes in these
marked positions.
FIG. 2
4. Insert expander plugs in the drilled holes.
FIG. 3
5. Screw on the bracket.
FIG. 4
6. Connect the live wire L (brown), neutral
wire N (blue) and earth wire (yellow/
green).
FIG. 5
FIG. 6
7. Fit the lamp housing on the bracket.
FIG. 7
8. Connect the power supply.
NOTE:
The product is only intended to be mounted
on a wall.
12