Ormed ARTROMOT-SP3 Mode D'emploi page 63

programmed dorsal extension value
(display ). After that it attempts to
attain another 5 °, moving even
slower than before (display
If a high resistance toward the addi-
tional 5 ° is sensed, the reverse on
load function is automatically acti-
vated and the carriage moves in the
opposite direction.
This stretch cycle is repeated ten
times.
After that the carriage moves to the
programmed maximum plantar flexion
value and restarts the dorsal exten-
sion stretch cycle.
default setting: disabled
Note!
- If a pause is programmed when you
enable the function, the carriage
will stop for the duration of the
pause each time the maximum
stretching value is attained.
- Enabling the stretching in dorsal ex-
tension function automatically dis-
ables motor B. The only movement
performed is dorsal extension /
plantar flexion.
- It is not possible to combine a sec-
ond stretching function with the
special function "stretching in dor-
sal extension".
- During operation the display will
show the symbol
■ stretching in plantar flexion
With the special "stretching in plantar
flexion" function the carriage gently
stretches the joint by bending the foot
downward.
Starting at the middle position the
carriage will first move to the pro-
grammed dorsal extension value and
then to the programmed plantar flex-
ion value.
Subsequently the carriage reverses 5°
towards dorsal extension and then
moves very slowly back again to the
programmed plantar flexion value
(display ). After that it attempts to
attain another 5°, moving even slower
than before (display
).
■ stretching in inversion
.
).
63
If a high resistance toward the addi-
tional 5° is sensed, the reverse on
load function is automatically acti-
vated and the carriage moves in the
opposite direction.
This stretch cycle is repeated ten
times.
After that the carriage moves to the
programmed maximum dorsal exten-
sion value and restarts the plantar
flexion stretch cycle.
default setting: disabled
Note!
- If a pause is programmed when you
enable the function, the carriage
will stop for the duration of the
pause each time the maximum
stretching value is attained.
- Enabling the plantar flexion stretch
function automatically disables
motor B. The only movement per-
formed is dorsal extension / plantar
flexion.
- It is not possible to combine a sec-
ond stretching function with the
special function "stretching in plan-
tar flexion".
- During operation the display will
show the symbol
With the special "stretching in inver-
sion" function the carriage gently
stretches the joint towards the inside.
Starting at the middle position the
carriage will first move to the pro-
grammed eversion value and then to
the programmed inversion value.
Subsequently the carriage reverses
5° towards eversion and then moves
very slowly back again to the pro-
grammed inversion value (display
for the right foot and
left foot). After that it attempts to at-
tain another 5°, moving even slower
than before (display
foot and for the left foot).
If a high resistance toward the addi-
tional 5° is sensed, the reverse on load
function is automatically activated
.
for the
for the right