Mounting The Kombitool - Stihl KB-KM Notice D'emploi

5
3
5
Loosen the clamp screws (5).
N
Push the gearbox (6) onto the drive
N
tube (3), turn the gearbox back and
forth as necessary.
Aligning the Gearbox
Line up the gearbox on the drive
N
tube so that the distance between
the horizontal axles (7) and the
deflector is the same at both sides.
Tighten down the clamp screws
N
firmly.
KB-KM, KW-KM
WARNING
It must not be possible to rotate the
gearbox on the drive tube.
6
Mount the two sweeping
N
attachments – see "Replacing the
Sweeping Attachmenrs".

Mounting the KombiTool

2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
English
9