Assembling the Unit
Pull the protective caps off the ends
N
of the drive tube and keep them in a
safe place for later use – see
"Storing the Machine".
NOTICE
The plug may come out of the drive tube
when you pull off the cap. Push it back
into the drive tube as far as stop.
FCS-KM
Mounting the Gearbox
1
2
Loosen the clamp screw (1) on the
N
gearbox (2).
Push the drive tube (3) through the
N
clamp and into the gearbox – turn
the gearbox back and forth as
necessary.
Once the end of the drive tube is
N
inserted beyond the slot (see arrow)
in the clamp (5), push it full home as
far as stop.
Tighten down the clamp screw
N
moderately.
2
3
1
4
Line up the gearbox (2) on the drive
N
tube (3) so that the lug (arrow)
points vertically upwards when the
depth wheel (4) is vertical.
Tighten down the clamp screws (1)
N
firmly.
Mounting the KombiTool
2
3
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
English
1
3
4
9