Storing The Machine; Replacing The Sweeping Attachments - Stihl KB-KM Notice D'emploi

English
NOTICE
Do not stand or kneel on the drive tube.
WARNING
The sweeping attachments may begin to
rotate and cause the machine to move
as soon as the engine starts. For this
reason, blip the throttle after starting –
the engine returns to idling speed.
The starting procedure is now as
described in the instruction manual of
the KombiEngine or basic power tool
you are using.
Stopping the Engine
See instruction manual of the
N
KombiEngine or basic power tool.
12

Storing the Machine

For periods of 3 months or longer
Remove and clean the sweeping
N
attachments, inspect them for
damage and wear.
If the KombiTool is removed from
N
the KombiEngine and stored
separately: Fit the protective cap on
the drive tube to avoid dirt getting
into the coupling.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.
Replacing the Sweeping
Attachments
Bristle Brush
Removing
Remove the hitch pin (1) from the
N
end of the axle (2).
Pull the bristle brush (3) off the axle.
N
Installing
Push the bristle brush (3) onto the
N
axle.
Insert the hitch pin (1) in the hole at
N
the end of the axle and fold it flat.
Use the same procedure to mout
N
the other bristle brush.
WARNING
Always mount both bristle brushes.
KB-KM, KW-KM