Storing The Machine; Maintaining The Mowing Head - Stihl FSB-KM Notice D'emploi

English
Make sure you have a firm footing,
N
either standing, stooping or
kneeling.
Hold the machine with you left hand
N
and press it down firmly – do not
touch the controls on the control
handle – see KombiEngine or basic
power tool instruction manual.
NOTICE
Do not stand or kneel on the drive tube.
WARNING
The cutting attachment may begin to
move as soon as the engine starts. For
this reason, blip the throttle after starting
– the engine returns to idling speed.
The starting procedure is now as
described in the instruction manual of
the KombiEngine or basic power tool
you are using.
Stopping the Engine
See KombiEngine or basic power
N
tool instruction manual.
14

Storing the Machine

For periods of 3 months or longer
Remove, clean and inspect the
N
cutting attachment.
If the KombiTool is removed from
N
the KombiEngine and stored
separately: Fit the protective cap on
the drive tube to avoid dirt getting
into the coupling.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.
Maintaining the Mowing
Head
Placing power tool on the ground
Switch off the engine.
N
Lay your trimmer on its back with
N
the loop handle and shroud pointing
down and the output shaft facing up.
Adjusting nylon line
STIHL AutoCut
With the engine running, hold the
N
rotating mowing head above the
grass surface.
Tap it on the ground once – fresh
N
line is advanced and the blade on
the deflector trims it to the right
length.
Fresh line is advanced every time the
mowing head is tapped on the ground.
For this reason observe the mowing
head's cutting performance during
operation. If the mowing head is tapped
on the ground too often, the line limiter
blade will unnecessarily cut off unused
lengths of nylon line.
Line feed operates only if both lines are
still at least 2.5 cm (1 in) long.
FSB-KM