Approved Kombiengines - Stihl KB-KM Notice D'emploi

PowerSweep
The KW-KM PowerSweep KombiTool is
used for sweeping areas and paths,
moving wet materials, such a leaves or
dirt to a central point, clearing snow and
removing standing water from solid
surfaces.
Push the PowerSweep steadily at
N
walking pace.
Always hold and guide the tool at a
N
shallow angle.
KB-KM, KW-KM
WARNING
The steeper the angle shown above, the
more difficult it is to control the tool.
1
Guide the PowerSweep at right
N
angles to the direction of travel (1).
Sweepings are thrown forwards,
ahead of the operator.
WARNING
The PowerSweep pushes back towards
the operator.
Cleaning the Sweeping Attachment
Clean away any dirt and debris that has
accumulated between the sweeping
attachments, around the gearbox or
between the sweeping attachments and
the deflector:
Shut off the engine.
–
Pull the hitch pins out of the axle.
–
Remove the sweeping attachments
–
from the axle and clean them.
Clean away dirt and debris from the
–
machine.
Refit the sweeping attachments – see
"Replacing the Sweeping Attachments".

Approved KombiEngines

Only use KombiEngines supplied by
STIHL or expressly approved by STIHL
for use with the attachment.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHL KM 55 R, KM 56 R, KM 85 R
KM 90 R, KM 94 R, KM 100 R,
1)
KM 110 R , KM 130 R, KMA 130 R
WARNING
Loop-handled machines must be
equipped with a barrier bar.
1)
outside the EU only
English
1)
,
7