Intended Use; Mounting The Tool; Mounting The Cutting Attachment - Stihl AWG Mode D'emploi

English

Intended use

The STIHL balancer accurately
measures radial and axial out-of-
balance on cutting attachments with two
or more teeth.
Out-of-balance causes vibrations
on high speed cutting attachments
which are transmitted to the
power tool and increase the risk
of accidents.
Do not exceed the maximum limit
for imbalance specified by STIHL.
Out-of-balance can occur when the
teeth of cutting attachments are
resharpened unevenly.
N Test the cutting attachment during
or after resharpening.
12

Mounting the Tool

N Mount the balancer on a vertical
surface, leaving sufficient clearance
for larger cutting attachments.
N
Protect the balance from dust and
dirt.
Mounting the Cutting
Attachment
Fitting the Cutting Attachment
N Push the annular magnet (1) back
against the mounting.
1
AWG