Charging The Battery, Leds; Displaying State Of Charge; Assembling The Pole Pruner; Mounting The Guide Bar And Saw Chain - Stihl HTA 66 Notice D'emploi

6 Charging the Battery, LEDs

6 Charging the Battery, LEDs
6.1 Charging the Battery
The charging time depends on several factors,
e.g. temperature of the battery or the ambient
temperature. The actual charging time may differ
from the specified charging time. For specified
charging times see www.stihl.com/charging-
times.
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300,
500 chargers.
6.2

Displaying State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
18.
There is a malfunction in the pole pruner or
battery.
7 Assembling the Pole Pru‐
ner
7.1

Assembling the Pole Pruner

(HTA 86)
► Switch off the pole pruner and remove the bat‐
tery.
0458-191-9621-B
1
► Align the shaft (1) as shown in the figure.
► Push the shaft (1) into the clamping piece (3)
in such a way that the recesses (5 and 6) are
in line.
► Push the shaft (1) into the clamping piece (3)
as far as it will go in such a way that the
clamping piece (3) is over the handle hose (7).
80-100%
60-80%
Take care not to damage the cable (2).
40-60%
► Fully tighten the screw (4).
20-40%
The shaft need not be removed again.
0-20%
7.2
7.2.1
The guide bar and saw chain combinations that
can be used with the chain sprocket are listed in
the specifications,
► Switch off the pole pruner and remove the bat‐
tery.
► Rotate the nut (1) counterclockwise until the
chain sprocket cover (2) can be removed.
► Remove the chain sprocket cover (2).
► Turn the tensioning screw (3) counterclock‐
wise until the tensioner slide (4) butts against
the left end of the housing.
3
2
4
5
6
90°
7
Mounting and Removing the
Bar and Chain
Mounting the Guide Bar and Saw
Chain
20.1.
4
2
1
English
90°
3
37