Gaggia K 111 Mode D'emploi page 29

Cooling the coffee machine
Caution
Steam and hot water can cause burns.
Never aim the steam or hot water flow towards parts
of your body. Do not touch the hot parts of the coffee
machine, i.e. the steam wand. Do Not use the steam
function unless a suitable receptacle has been placed
under the steam wand.
The coffee making function requires a lower
temperature than the steam dispensing and froth
making functions.
If you wish to make a coffee and you have just used
the steam function, you should allow the appliance to
cool down first. However, a short-cut is possible:
• Place and hold a suitable receptable under the steam wand. Turn the knob slowly
anti-clockwise. Then, push the coffee selection button (Fig.18). The steam wand will
dispence steam first and then hot water.
• When the light for coffee ready illuminates steadily, turn the knob full clockwise
Hot water function
This function is convenient to prepare tee and hot beverages.
• Press the ON/OFF button to turn ON the appliance. The light for machine ready () will
turn on. When the light for machine ready () illuminates steadily, the appliance will be
ready for use.
• Place a suitable receptacle under the steam wand. Slowly rotate the knob anti-clockwise
and push the coffee selection button (Fig.18). Hot water will flow out of the steam wand.
• Once the desired amount of hot water has been dispensed, stop the function by firstly,
push the coffee button again, and then turn the steam knob fully clockwise.
Note:
The coffee machine incorporates an advanced electronic system to control its numerous
functions for making coffee and dispensing steam.
To prevent malfunctions, do not turn on the coffee machine immediately after turning it
off. Wait about 0 seconds before switching it on again. Also, adhere to the operating
instruction
Fig. 18
9