livin flame Skomo Mode D'emploi Et D'installation page 40

Place the flange and the seal on the back fumes
box (Pic. 5-6). This flange can be used as inspection
compartment.
Pic. 5
Pic. 6
In order to achieve the test report results, please load the performance parameters retained by
the manufacturer and the qualified tecnichian. They will use these parameters once verified
that, during the installation, it is possibile to reproduce the laboratory conditions.
6
Take the 80mm diameter flue connection (placed
into the tank) and install it with high temperature
silicone in the specific connection (Pic. 7-8).
Pic. 7
Pic.8
Follow the instructions in the next chapters for the
flue pipe connection, bearing in mind that in case
of upward flue outlet it is not necessary to install
the T-fitting.