Publicité
Les langues disponibles
Les langues disponibles
Norms and declarations of conformity
Our company declares that the stove conforms to
the following norms for the EC European Directive
labelling:
• 2014/30 UE (regulation EMCD) and following
amendments;
• 2014/35 UE (Low Voltage Directive) and following
amendments;
• 2011/65 EU (RoHS 2 directive);
• The Rules of Construction Products (CPR-
Construction Products Regulation) No. 305/2011
regarding the construction world;
• For installations in Italy, please refer to UNI
10683/98 or following changes. While installing
the unit respect the local, national and
Europen rules;
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN
61000-3-3; EN 60335-1; EN 60335-2-102; EN
62233, EN 50581.
Safety information
Please carefully read this use and maintenance
manual before installing and operating the stove!
If clarification is needed, please contact the dealer
or the Authorized Assistance Center.
• The pellet stove must only be operated in living
environments. This stove, being controlled by an
electronic board, permits a completely automatic
and controlled combustion; the exchange, in fact,
regulates the lighting phase, 5 power levels and the
shut down stage, guaranteeing the safe operation
of the stove.
• The basket used for combustion allows most
of the ash produced by the combustion of the
pellets to fall into the collection compartment.
Nevertheless, check the basket daily, given that
not all pellets have high quality standards (use only
quality pellets recommended by the manufacturer).
Responsibility
With the delivery of the present manual, we
decline all responsibility, both civil and penal, for
accidents deriving from the partial or total lack of
observance of the instructions contained herein.
We decline every responsibility derived from
improper use of the stove, from incorrect use by
the user, from unauthorized modifications and/
or repairs, from the use of replacement parts that
are not original for this model. The manufacturer
declines every civil or penal, direct or indirect
responsibility due to:
• Lack of maintenance;
2
• Failure to observe the instructions contained in
the manual;
• Use in non-conformity with the safety directives;
• Installation in non-conformity with the norms in
force in the country;
• Installation by unqualified or untrained personnel;
• Modifications and repairs not authorized by the
manufacturer;
• Use of non-original replacement parts;
• Exceptional events.
• Use only wood pellets;
• Keep / store the pellets in a cool
dry place;
• Never pour pellets directly on the hearth;
• The stove must only be fed with quality 6
mm diameter pellets, A1 certified according
to the UNI EN ISO 17225-2 regulations;
• Before making the electrical connection
of the stove the discharge tubes must be
connected with the flue;
• The protective grill placed inside the
pellet container must never be removed;
• The environment where the stove is
installed must have a sufficient exchange
of air;
• It is forbidden to operate the stove with
the door open or the glass broken;
• Do not use the stove as an incinerator;
the stove should be used only for the
intended purpose;
• Any other use is considered improper
and therefore dangerous. Do not put in
the hopper other than wood pellets;
• When the stove is operating, the surfaces,
glass, handle and tubes become very hot:
during operation do not touch these parts
without adequate protection;
• Keep the fuel and other inflammable
materials off the stove.
Publicité
