livin flame Skomo Mode D'emploi Et D'installation page 39

Back fl ue pipe connection
The default stove is supplied already equipped
with the back fl ue outlet. In this case it is necessary
fi rst to assembly the 80mm fl ue pipe connection,
placed into the tank, with high temperature
silicone on the back fumes box. (Pic.1)
Upper fl ue pipe connection
As the default stove is equipped with the back
fl ue outlet, it is necessary to remove the aesthetic
covering by unscrewing the screws (Pic. 2) and
lifting it upwards (Pic. 3).
Pic. 2
Pic. 3
Pic. 1
Then break the covering pre-cut. remove the
fl ange and the seal pre-installed at the fl ue pipe
exit (Pic. 4).
Pic. 4
5