IKRA AT 3351 A Manuel D'utilisation page 21

1. Pull the fuel suction head (B) out of the tank using a
hook (C) or similar tool (Fig. 28).
2. Pull the suction head off by concurrently turning it (Fig.
28).
3. Replace the fi lter (D).
NOTE : Never use the trimmer without a fuel fi lter. This
may result in severe damage to the engine.
CARBURETTOR SETTINGS
The carburettor has an optimised setting 'ex works'. If
any further adjustments should be required contact your
competent customer service.
SPARK PLUG
1. Spark plug air gap : 0.635mm (Fig. 29)
2. Tighten the spark plug with a torque of 12-15Nm. Put
the spark plug connector on the spark plug.
SHARPENING THE CORD CUTTER
1. Remove the cutter (E) from the protection cover (F)
(Fig. 30).
2. Put the cutter into a vice and fi x it fi rmly. Sharpen the
cutter using a fl at fi le. File with care and keep the
sharpening angle. Always fi le in one direction only.
STORAGE
1. Follow all aforementioned maintenance instructions.
2. Thoroughly clean the trimmer and grease the metal
parts.
3. Empty the fuel tank and screw the tank cap back on.
4. After the tank has been emptied, start the engine.
5. Let the engine idle until it stops to free the carburettor
from fuel.
6. Let the engine cool down (about 5 minutes).
7. Remove the spark plug using a spark plug wrench.
8. Fill a tea spoon of pure 2-stroke oil into the combustion
chamber. Pull the starter rope several times slowly to
distribute the oil inside the engine. Put the spark plug
back in.
9. Store the device in a cool, dry place where it is protected
from open fl ames and sources of heat as fl ow heaters,
oil-fi red boilers etc.
ATTENTION : Any maintenance works that are not
explicitly described in these Operating Instructions
must be carried out by an authorized workshop.
To ensure a consistent and proper operation use
ORIGINAL SPARE PARTS only.
REOPERATION
1. Remove the spark plug.
2. Pull the starter rope quickly to its full extent to remove
any remaining oil from the combustion chamber.
3. Clean the spark plug and check the gap. Replace the
plug if required.
4. Prepare the device for operation.
5. Fill the tank with the proper fuel/oil mixture. See chapter
'Fuels and lubricants'.
WASTE DISPOSAL AND ENVIRONMENTAL
PROTECTION
Never pour remainders of chain lubricant or 2-stroke fuel
mixture in the drain or sewerage system or soil, but dispose
of it in a proper, environmentally friendly way, e.g., at a
special collecting point or dump.
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Thoroughly empty the oil/lubricant and fuel tanks and
dispose of the remainders at a special collecting point
or dump. Please also dispose of the device itself at an
according collecting/recycling point. By doing so, plastic
and metal parts can be separated and recycled. Informa-
tion concerning the disposal of materials and devices are
available from your local administration.
GB-6