Dräger X-zone 5000 Notice D'utilisation page 46

Establishing a wireless connection
4.2.6 Terminating group
1. Press the key on the main device to open the menu.
OK
2. Select and confirm .
3. Select and confirm
Display on main and group devices:
Grouping LED: off.
46
to ungroup the group.
ARCL-0144
4.2.7 Provisionally deactivating group monitoring
If group monitoring is provisionally deactivated, the associated
alarm function is provisionally deactivated as a result. The
connection status display and the group assignment for the
devices are retained.
To deactivate the group monitoring provisionally:
1. Form group with closed wireless network.
2. Press the
OK
3. Select and confirm
4. Select and confirm
monitoring provisionally.
Group monitoring is deactivated.

Group monitoring is automatically activated 15 minutes after
provisional deactivation or after switching on grouped devices.
This interval is shown as follows:
For the first 13 minutes the communication LED flashes

slowly.
For the last 2 minutes the communication LED flashes

04333112.eps quickly.
NOTICE
i i
The gas alarms remain displayed with the group
monitoring deactivated.
4.2.8 Activating group monitoring
1. Form group with closed wireless network.
2. Press the
OK
3. Select and confirm
4. Select and confirm
Group monitoring is activated.

4.2.9 Terminating group in an alarm situation
If the main device can no longer be found for a group device
(communication LED flashes red), the grouping for this device
can be cleared.
To ungroup the group:
1. Press the
OK
2. Select and confirm
3. Select and confirm
or
Press key on the group device for a long time.

Group affiliation is deleted.

key on the main device to open the menu.
.
to deactivate the group
key on the main device to open the menu.
.
to activate the group monitoring.
key on the group device to open the menu.
.
to ungroup the group.
Dräger X-zone 5000