Correct Wiring Of The Control Cables - Lenze 9300 vector Instructions De Montage

Show/Hide Bookmarks
4 Electrical installation

Correct wiring of the control cables

4.6 Correct wiring of the control cables
0
Fig.9-11
Terminal data
Cable type
72
1
Connection of the cable shield with shield clip and strain relief with cable binder
Shield sheet
Fasten shield sheet with two screws M4 × 12 mm at the bottom of the control card
Connect cable shield with shield clip to the shield sheet
Provide a strain relief of the control cable at the shield sheet by means of a cable binder
Wire end ferrule
Rigid –
Without wire end
Flexible
ferrule
Wire end ferrule
Flexible
without plastic sleeve
Wire end ferrule with
Flexible
plastic sleeve
2
3
Cable cross-section Tightening torque Stripping length
2
2.5 mm (AWG 14)
2
2.5 mm (AWG 14)
0.5 ... 0.6 Nm 0.5 ... 0.6 Nm
(4.4 ... 5.3 lb-in)
2
2.5 mm (AWG 14)
2
2.5 mm (AWG 14)
9300vec063
5 mm
EDKVF9383 DE/EN/FR 1.0