Optelec Compact 10 HD Manuel D'utilisation page 57

Optelec
RoHS Compliance
This product is in compliance with Directive 2011/65/EU of the European Parliament and of
the Council of 3 January 2013, on the restriction of the use of certain hazardous substances in
electrical and electronic equipment (RoHS-II) and its amendments.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Susceptibility to interference
There may be temporary degradation of the image when Compact 10 HD is subjected to a strong radio
frequency field, electrostatic discharge, or transient electrical noise. An electrostatic discharge (caused by
static electricity) may cause the screen to go blank. If this happens, follow these steps:
1. Disconnect the DC adapter power supply from the electrical outlet.
2. Wait 30 seconds.
3. Connect the DC adapter power supply again.
Caution for battery pack
BATTERY NEEDS TO BE REPLACED BY CERTIFIED SERVICE PERSONNEL.
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE REGULATIONS.
English
This device bears the CE and FCC approval mark.
Compact 10 HD & Compact 10 HD Speech
57