Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Run home power supply cable through strain relief, into
terminal box.
A
C
D
E
A. Home power supply cable
B. UL listed or CSA approved strain relief
C. Black wires
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-green ground wires
5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (F) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
NOTE: Remove the film from the vertical duct cover supports and
B
the duct covers.
1. Attach the vertical duct cover supports using 8 - 4 x 8 mm
F
2. Slide the upper duct covers into place, and insert 3 tabs on
3. Slide the lower duct covers over the upper duct covers.
4. Attach the lower duct covers together using a plastic bracket
Install Duct Covers
screws.
A. Screws
B. Vertical duct cover support
each side of the duct covers into the mating slots of the
vertical duct cover supports. Slide the duct covers up until
the springs "click" and the tabs are locked in place.
A
B
A. Upper duct cover
B. Spring
at each top and bottom corner of the lower duct covers
(4 places).
C
A. Upper duct cover
B. Lower duct cover
C. Plastic brackets
A
B
A
A
B
C
9
Publicité
Table des Matières
