Tecnodom SALINA 80 Manuel D'installation Et De Fonctionnement page 29

ATTENTION
In order to allow a good functioning of the equipment please pay attentions to the following instructions:
• Do not place the unit in an area directly exposed to sun light or to other heating sources, such as
high intensity incandescent lighting systems, ovens or other radiant heating sources, e.g. heating radiators etc.
• Do not place the unit nearby door openings producing air currents, whether doors or windows
or directly exposed to air from fans, vents or fan coil unit air conditioner.
• Do not block or obstruct the air inlets of the built-in refrigeration unit.
• Do not place any objects on the unit, including boxes or any other type of objects; leave the entire
perimeter of the unit completely free so that air can circulate properly.
• Do not place the equipment inside areas with high relative humidity levels (it may cause forma-
tion of condensation)
• Do not place the equipment inside a closed niche, as there is not enough air circulation and may
cause the refrigeration unit to not work properly.
• Do not place the unit one above another.
• Verify that the room in which the equipment is placed must be sufficiently aired, even when the shop is closed.
Verify that in the installation room there is enough air turnover, even during closing and rest hours. In
this way the expansion/condensing unit will work correctly.
• Keep a MINIMUM distance ok 60cm from the front of the grille on the motor side
Keep a MINIMUM distance of 10 cm from the back of the unit from the wall, so as to prevent
•
the formation of condensate.
INSTALLATION MINIMUM DISTANCE
In order to allow a good performance of the cabinet, during the installation you must respect the MINIMUM
WALL distances as showed on the drawings.
1.6 WATER CONDENSATION DRAIN / WATER DRAIN CONNECTION
The Serve-over Display with built-in unit is fitted with manual evaporating water condensation tank. Ve-
rified that the water pipe is correct positioned and periodically and the basin is must be cleaned from waste materials.
The Serve-over Display with remote unit, not having the basin for water collection is provided with
a siphon only, the customer take care of the water connection pipe. Its connection to the principal basin prevents
the circulation of cold air and of bad smells. The Serve-over Display cannot absolutely be installed without
siphon and each drain must have its own siphon. It is necessary to have the drain-siphon after the exit of belly
section to block the out-take air and also to avoid any smell. You never install the Serve-over Display without siphon
and to connect more drains of the same Serve-over Display together. Each drain must have only one siphon.
SALINA - KIBUK | User and Maintenance Manual | EN
29