Cleaning - Beurer HC 45 Ocean Mode D'emploi

Hair with volume and bounce
1. Depending on your hair type, set the volumising and hair-drying brush to set-
ting 1 or 2.
2. Place the brush head [2] over a section of hair at the tips.
3. Wrap the section of hair, up to the roots, around the brush head [2] in an inwards
or outwards direction, whichever you prefer.
4. Hold this position for approximately 20 seconds.
5. After the 20 seconds, slide the sliding switch [4] to setting
6. Unwind the section completely in the opposite direction.
7. Repeat the instructions for each section of hair to curl the rest of your hair.
Note
If your hair becomes knotted while winding or unwinding, switch off the device and
carefully release the hair from the brush head [2].

5. CLEANING

Important
• Always pull the mains plug out of the socket before cleaning the device. Risk of
electric shock!
• Before each use, remove any sucked-in fl uff , dust or hair from the air outlets [2]
and the air intake fi lter [5] using an appropriately sized brush.
• Hair that has remained on the brush head [2] after use can be removed by hand
once the device has cooled down.
18
to fi nish the section.