Service/Maintenance - Dustcontrol DC 1800H Traduction Des Instructions De Service D'origine

Open and close the hatch on the side 3-6 times. Air flows into the machine and cleans the filter by creating a reverse pulse.
2. Turn off the machine and let the material fall down. Reconnect the suction pipe.
3. Start the machine.
Emptying
• The container underneath the cyclone should be emptied when about 2/3 full.
• You can use the machine with or without a plastic bag in the container.
• You must clean the filters before replacing the plastic bag.
• The plastic bag must be sealed as soon as it is removed from the container.
• Only use original bags as there must be no creases around the edge of the container. This tight seal prevents the bag from
being suctioned up.
The container underneath the cyclone should be emptied when it is filled to about 2/3 or contains a maximum of 20 kg.
When emptying, carefully release the two fasteners, one at a time, so that dust is not stirred up unnecessarily. After lowering the
container (on DC 2800 H) or lifting the upper part of the machine (on DC 1800 H), turn on the dust extractor again so that any air
borne particles are sucked into the filter cyclone. The container can now be completely removed from the machine. Carefully
remove the entire bag from the edge of the container and seal it immediately. Then fit a new plastic bag in the container, carefully
folding the open end over the edge of the container. Ensure that the plastic bag is intact with no visible creases. Carefully put the
container back under the extractor unit. Attach the two fasteners, switch off the machine, re-attach the container and check for
any leaks.
For best results:
• When attaching the plastic bag, ensure that there is no air between the plastic bag and the container.
• Ensure that air does not enter between the container and the bag when the machine is running.

Service/Maintenance

WARNING
The manufacturer or a trained person must carry out an inspection at least once a year. Check, for example, if
the filters are damaged, the dust extractor's air tightness and the operation of the control unit, and inspect the
electrical components, seals and cables for equalization so that they are not damaged.
Potential equalization checks should be carried out regularly when modifications or repairs are made in the
system.
Filter change
DC 1800H/DC 2800H, Art.nr. 9497-H 17