Usb Playback And Recording; Using The Usb Interface; Recording The Tracks Of A Music Cd On A Usb Device; Recording All The Tracks - Pioneer DCS-585 Mode D'emploi

07

USB playback and Recording

Chapter 7
USB playback and Recording

Using the USB interface

It is possible to listen to two-channel audio
and watch DivX video/WMV/JPEG files using
the USB interface on the front of this unit.
Connect a USB mass storage device
shown below.
1 With the player switched on, press USB.
Make sure your TV is on and set to the correct
video input.
2 Connect your USB device.
The USB terminal is located on the front panel.
(Type A)
USB mass
storage device
3 Press  (play) to start playback.
If your USB device contains JPEGs, a
slideshow will start. See Playing a JPEG
slideshow on page 26 for more on this.
• Make sure USB DATA is showing in the
front panel display (or the system is in
standby) when disconnecting.
Note
1 This includes playback of DivX video/WMV/WMA/MP3/MPEG-4 AAC files (except files with copy-protection or restricted
playback).
2 • Compatible USB devices include external magnetic hard drives, portable flash memory (particularly keydrives) and digital
audio players (MP3 players) of format FAT16/32. It is not possible to connect this unit to a personal computer for USB playback.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no
responsibility for any loss of data that may occur when connected to this unit.
• With large amounts of data, it may take longer for the system to read the contents of a USB device.
• Some USB devices may not be properly recognized.
• Even when they are in a supported format, some files may not play or display depending on the content.
32
En
2
as
USB
USB
USB
Important
If a USB ERR message lights in the display, it
1
may mean that the power requirements of the
USB device are too high for this player, or that
the device is incompatible. Try the following:
• Switch the player off, then on again.
• Reconnecting the USB device with the
player switched off.
• Selecting to another input source (like
DVD/CD), then back to USB.
• Using a dedicated AC adapter (supplied
with the device) for USB power.
If this doesn't remedy the problem, it is likely
your USB device is incompatible.
Recording the tracks of a
music CD on a USB device
The tracks of a music CD loaded in this unit
can be recorded on a USB connected to the
USB port.

Recording all the tracks

1 Load the music CD.
Press  to stop playback.