Reducing Am Reception Noise; Memorizing Stations; Listening To Station Presets; Audio Input Settings From The Tvs (Tv Input) - Pioneer DCS-585 Mode D'emploi

Getting started

Reducing AM reception noise

If AM reception seems particularly poor, or the
AM radio station you're listening to seems
noisy, try using the Noise Cut feature for better
sound quality.
1 Tune to an AM radio station then press
SHIFT+SETUP.
Use / to choose TUNERSET then
2
press ENTER.
Use / to choose NOISECUT then press
3
ENTER.
Use / to select the noise cut mode
4
then press ENTER.
Select an effect level between 1 or 2.

Memorizing stations

This system can memorize up to 30 stations,
stored in three banks, or classes (A, B and C) of
10 stations each.
1 Tune to an AM or FM radio station.
Select mono or auto-stereo reception (FM) as
necessary. These settings are saved along with
the preset.
2 Press SHIFT+T.EDIT.
3 Press CLASS to select one of the three
classes, then use the PRESET buttons to select
the station preset you want.
You can also use the number buttons to select
a preset.
4 Press ENTER.
After pressing ENTER, the preset class and
number stop blinking and the system
memorize station.

Listening to station presets

You will need to have some presets stored to do
this.
1 Make sure the TUNER function is
selected.
2 Press CLASS to select the class in which
the channel is stored. Press repeatedly to
cycle through classes A, B and C.
3 Use the PRESET buttons to select a station
preset.
• You can also use the number buttons to do
this.
Audio input settings from the
TVs (TV Input)
To listen to audio from a flat screen TV on this
device, you will need to connect an audio cable
other than an HDMI cable. From this menu, set
the audio input to that which you would like to
connect. This setting is effective only when
KURO LINK is set to LINK ON and this unit is
connected with a KURO LINK-compatible
Pioneer flat screen TV (see KURO LINK Setup
on page 48).
Select from inputs DIGITAL AUDIO (LINE1),
ANALOG AUDIO (LINE2) and AV
CONNECTOR (LINE3).
Press SHIFT+SETUP and use / to
1
select SYS SET then press ENTER.
Use / to select TV INPUT, then press
2
ENTER.
Use / to adjust the setting then press
3
ENTER to confirm.

Listening to other sources

You can connect auxiliary sources (TV, satellite
receiver, etc.) to this unit for playback through
the speaker system. See Connecting auxiliary
components on page 42 for more on this.
• To connect a USB device to the USB
terminal, see USB playback and Recording
on page 32.
• Bluetooth ADAPTER is selectable when it is
plugged and detected. See Bluetooth
ADAPTER for Wireless Enjoyment of Music
on page 45 for more on this.
1 Make sure that the external source (TV,
satellite receiver, etc.) is switched on.
2 Press LINE to select the source.
Each press switches between LINE1, LINE2
and LINE3.
3 If necessary, start playback of the source.
04
®
21
En