Preparation Only For The Dcs-585 - Pioneer DCS-585 Mode D'emploi

01 Speaker Setup Guide
3 Fit the provided cap into the top of the
pole.
Pass the speaker cables through the middle of
the cap as shown in the illustration and fit the
cap.
4 Attach the provided metal catches to the
pole.
• Attach the metal catches so that they
sandwich the pole and then insert the
screw into the screw hole.
• Use caution so that the metal catches do
not slip or come off until the speaker is
installed.
The shape of the front-side metal catch is
different from that of the rear-side one.
Pay attention to the installation direction
of the metal catches.
5 Install the speaker.
• Connect the speaker cables to the
connectors of the speaker.
• Fit the screws (M5 x 12 mm) through the
metal catches that were attached in step 4
and into the screw holes in the speaker,
and temporarily tighten the screws.
8
En
CAUTION
Rear side
Front side
• Referring to the scale on the rear side of
the speaker, adjust the positions of the
right and left speaker stands to the same
height according to your preference, and
tighten the screws.
Screws
6 Finely adjust the positions of the two
poles.
Adjust the poles so that they are straight and
level when viewed directly from the side or
above.
OK

Preparation only for the DCS-585

Stack the speakers and fix the brackets
Each speaker is provided with a color-coded
indicator on the model label on the rear side to
assist identification. Refer to the color
indicators and install the speakers correctly.
NG