Wall Mounting The Speakers; Before Mounting - Pioneer DCS-585 Mode D'emploi

Speaker Setup Guide
As shown in the illustration, stack the
speakers. Align the bracket with the respective
upper and lower screw holes as shown in each
figure below and fasten the screws securely.
4 spot/3 spot speaker layout:
4 spot:
Left Right
Green Center speaker Green
Front speaker Red
White
Model label
Color indicator
Bracket
Screw
2 spot speaker layout:
Model label
Color indicator
Bracket
Screw
3 spot:
Left Right
Surround
Blue Gray
speaker
Front speaker Red
White
Front
speaker
Left Right
Blue Surround speaker Gray
Green Center speaker Green
White Front speaker Red
Surround
speaker
Center
speaker
Front
speaker
CAUTION
• Do not attempt to carry the speakers when
they are connected with the bracket. Doing
so may cause damage to the bracket or
worsen damage to the bracket and
speakers in the event they are dropped.

Wall mounting the speakers

For the DCS-585, attached mounting brackets
for the front, center and surround speakers
have mounting holes. For the DCS-590, only
the center speaker has a mounting hole. For
the DCS-FS30, the front speaker have
mounting holes.

Before mounting

• Remember that the speaker system is
heavy and that its weight could cause the
screws to work loose, or the wall material to
fail to support it, resulting in the speaker
falling. Make sure that the wall you intend
to mount the speakers on is strong enough
to support them. Do not mount on plywood
or soft surface walls.
• Mounting screws are not supplied. Use
screws suitable for the wall material and
support the weight of the speaker.
CAUTION
• If you are unsure of the qualities and
strength of the wall, consult a professional
for advice.
• Pioneer is not responsible for any
accidents or damage that result from
improper installation.
Mounting screw
(not supplied)
5 mm to 7 mm
01
5 mm
10 mm
9
En