Technical Data - AEG NDR 4156 DAB+ Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
13. If you want to be woken up with DAB or FM, select now
with what radio station you want to be woken up with.
The choices include the last heard radio station (LAST
LISTEND) and the stored radio stations (PRESET). Con-
firm your selection by pressing the AUTO SCAN / ENTER
button.
14. Press the UP button. The display will indicate "VOLUME:".
Press the AUTO SCAN / ENTER button.
15. Now select the volume for the wake-up. Press the UP or
DOWN button to select the desired setting. Confirm your
selection by pressing the AUTO SCAN / ENTER button.
16. Press the UP button. The display will indicate "SAVE:".
Press the AUTO SCAN / ENTER button. "ALARM
SAVED" appears briefly on the display.
17. Then with the STANDBY button switch the device to
standby.
The activated alarm function is indicated in the display by " ".
NOTE:
If you should use both alarm times, only one alarm symbol
is displayed because of technical reasons.
Switching off the Alarm Signal
Press the STANDBY button to switch off the alarm signal.
Automatic Alarm Interval
The automatically set alarm function can be switched off for
5 minutes with the SLEEP / SNOOZE / ALARM button.
NOTE:
If the Snooze function is activated, the time until the next
alarm is shown on the display.
Deactivate the Alarm Function
1. Proceed as shown in steps 1 to 4 of "Setting the Alarm
Time".
2. Press the AUTO SCAN / ENTER button to select the
"OFF" setting.
3. Press the UP button until "SAVE:" appears on the dis-
play. Press the AUTO SCAN / ENTER button. "ALARM
SAVED" appears briefly on the display.
Cleaning and maintenance
CAUTION:
Do not immerse the device in water.
• Disconnect the mains plug before cleaning.
• You may wipe off external stains, using a slightly damp
cloth without any additives.
NDR 4156 DAB+_K2
Troubleshooting
Problem
Cause
The unit
The unit is
cannot be
blocked and
operated.
"hangs".
No DAB Radio
Telescopic an-
reception.
tenna incorrectly
aligned.
No Digital Radio
can be received
in your area.
Problems with
Depending on
DAB radio
the location, you
reception.
may not be able
to receive some
stations at all or
with interference
in your region.
see also note on
page 45.
No sound.
Volume is too low. Increase the volume.
Poor sound
Radio signal too
quality.
weak.

Technical Data

Model: ...................................................................NDR 4156 DAB+
Power consumption:................................................................... 6 W
Battery operation: .........................................6 x 1.5 V, Type C / R 14
Net weight: .............................................................. approx. 1,22 kg
Radio section:
Frequency ranges:........................................FM 87.5 ~ 108.0 MHz
........................... DAB / DAB+ 174 ~ 240 MHz
External power adaptor
Input: .......................................................... AC 100 - 240 V, 50 / 60 Hz
Output: ........................................................................DC 9 V / 0,65 A
Polarity: ...................................................................................
Protection Class: ...............................................................................
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
English
47
Solution
Switch the unit off
using the ON / OFF
switch. Wait for
approx. 5 seconds
before switching the
unit on again.
Reset the device to
the factory defaults.
see "Resetting the
unit to the factory
settings".
Fully extend the
telescopic antenna
and align it vertically.
Switch to FM mode
to receive these sta-
tions. If these stations
are transmitted via
VHF. Find out more
on the internet site of
the radio station.
Try to adjust the
antenna position..
15.06.16

Publicité

Table des Matières
loading

Table des Matières