Plastics; Metals; Final Shutting Down - Kemper 150 0004 Mode D'emploi

KEMPER Welding Fumes Stationary Filter
Instruction Manual - EN

8.1 Plastics

Used plastics should be sorted out as much as possible.
Plastics should be disposed off while observing the duties imposed by law.

8.2 Metals

Different metals should be sorted out and disposed of. Disposal should be carried out
by an authorized company.

8.3 Final Shutting Down

Disassembly works must be carried out with utmost care to avoid stirring up dust
adhering onto the welding fumes filter and injury to the authorized personnel.
Therefore, it is necessary to disassemble the device in a well-ventilated room with
filtered exhaust air or a suitable mobile filtration unit. The work area should be
separated / marked. Raised dust should be immediately extracted by vacuum cleaner
of dust class "H".
During the work it is necessary to use personal protective equipment such as
protective clothing, gloves and breathing apparatus with incorporated fan, etc., so as
to avoid contact with hazardous dust.
Before disassembly the unit must be cleaned and freed of all dust. This should be
achieved using an industrial vacuum cleaner of dust class "H".
At the beginning of the disassembly the embedded filters are removed and disposed
of in an enclosed plastic bag. Then the loose dust is extracted during the
disassembly. Individual parts can then be divided by material and disposed of by an
authorized company.
Finally, it is necessary to clean the work area.
Order No.: 150 0004 - 77 - rev.: 0
Status as of: 04/2014
Technical changes and errors reserved.