Insert the changed filter in a plastic bag and seal it with cable ties. Suitable plastic
●
bags are available at KEMPER, under Order No. 119 0746.
Replace the filtration elements by new ones.
●
Close the service door, Pic. 14, pos. 4.
●
Turn the unit on. The green signal LED, Pic. 10 pos. 8) which indicates that
●
the main filter is OK, should be lit up.
Carry out welding only if the green LED is lit up.
●
Dispose of the used filter in accordance with the official regulations. Request
●
the relevant waste codes for these purposes from your local waste processor.
Finally clean the maintenance premises, for example by industrial vacuum cleaner
●
of dust class "H".
Order No.: 150 0004
Technical changes and errors reserved.
KEMPER Welding Fumes Stationary Filter
Picture 14, Filter structure
- 73 -
Instruction Manual - EN
rev.:
0
Status as of: 04/2014