Kemper 150 0004 Mode D'emploi page 62

Detection system
Extraction arm (a) 2 m /3 m /4 m
Extraction arm (a) 5m /6m /7m
Telescopic arm(s) 2 m
Mount the Control Box on the wall above the filtration unit in height of
●
approximately 1.5 m.
Install the extraction arm(s) according to configuration and length as described in
●
the current version of the instruction manual or in the installation manual.
Open the service door (pos. 4) on the welding fumes filter and insert
●
both filtration cartridges (pos. 5) back n the unit.
Close the service door (pos. 4) again.
●
Order No.: 150 0004
Technical changes and errors reserved.
Mounting height Z in [mm]
2,350
2,850
2,700
Picture 6, Inserting the filtration cartridge
- 62 -
KEMPER Welding Fumes Stationary Filter
Instruction Manual - EN
rev.: 0
Status as of: 04/2014