Drill four holes required for installation in the selected substrate. Find out the
●
dimensions in the diagram (Picture 5) and in the table of dimensions on the next
page.
Install the unit using suitable mounting material to the selected substrate (wall,
●
column, etc.). Follow all instructions mentioned on page 16. + 17,
par. 5.2 Conditions for installation and
●
par. 5.3 Filtration unit installation
●
Order No.: 150 0004
Technical changes and errors reserved.
KEMPER Welding Fumes Stationary Filter
Picture 5, Filtration unit installation
- 61 -
Instruction Manual - EN
rev.:
0
Status as of: 04/2014